Audi TT Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
64 Posts
Discussion Starter · #1 ·
I was changing my side light bulbs today and on the passenger side managed to snap the metal clip that holds the light covers tight out of its plastic mounts. I have managed to wedge the cover shut but its not as tight as it would be when clipped in properly. Does anyone know if much water even reaches this area? I can't see that it would but wanted to make sure.

If not, does anyone have any tips on how to keep it shut properly?
 

·
Registered
Joined
·
1,408 Posts
Get a clip from Audi . Its not the water I'd worry about its more the moisture that condensates inside that does the damage from not being sealed properly .
 

·
Registered
Joined
·
1,408 Posts
Epoxy the plastic bit back on reattach metal clip job done . Get hour or half hour epoxy as it is stronger than the 5/15 min stuff. Your first post says you broke the metal clip mate. Hence my first post.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top