Audi TT Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi everyone,I need to reinstate an Audi four rings badge below my rear boot lid spoiler as the original one has mysteriously disappeared!Are there any set dimensions for sticking my new badge back on?
 

·
Registered
Joined
·
436 Posts
Ask the guy who stole yours to put them on his car :wink:
 

·
Registered
Joined
·
3,114 Posts
5UBY said:
Ask the guy who stole yours to put them on his car :wink:
Well, I'm sure he will put them on his car without being asked? :wink:

Top edge of ring sits 43mm below where spoiler meets boot.
 

·
Registered
Joined
·
19,096 Posts
I am sure some kind soul will measure it for you, in fact I think this was mentioned within the last few weeks. I would just leave it off if I were you, clean up the sticky mess and give it a polish = hey presto the car appears lower and wider - best of all it's free and someone else has done some of the work for you :)



Charlie
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top